Atlas-Deco

LiveDive

Parameters

Dive

Mode Model GF low / high

SP descent SP bottom & deco Bail-out GF low / high

Route (legs)

Depth and runtime at end of each leg ; runtime 0 = gas switch during descent (travel gas). Order is followed.

		Depth m	Runtime min	Tank	Mix	O2 %	He %	Mix	Tank	L	Start	Reserve	Bottom gas

Approach / travel leg from a distance

Time = distance ÷ (speed × current factor). Adds a leg at the given depth before the bottom, and a return leg after it if ticked. Distances must come from your own measurement or a sourced site sheet.

Depth m Distance m Speed m/min Current factor Return

Onboard: Diluent & Oxygen

Diluent O2 % / He % Diluent flush ppO2 target List

CCR Tanks & Loop Parameters

The diluent is breathed on every leg (loop) ; in "tanks only" it is also an output of the ranking and stays editable.

Onboard tanks: O2 use = metabolic VO2 × loop time; diluent = loop volume × descent pressure rise + flushes at max depth. Both × safety factor. Estimates, not measurements.

	Tank	L	Start	Reserve
O2
Dil

VO2 L/min Safety factor Loop volume L Diluent flushes

Deco gases and tanks

BO RMV bottom → 1st stop (L/min) BO RMV deco (L/min) BO RMV bottom applies until BO Switch Extra Time min Bail-out bottom ppO2 max

	Role	O2 %	He %	Mix	L	Tank	Start	Reserve	Lost	Opt.

Turn Pressure CalculationStress RMV L/min Use Reserve

Travel Gas Split Use Reserve

Gas Lists

Parameters

Rates

Descent m/min To 1st stop Between stops To surface

Stops

Last stop m Gas switch time Air breaks (on O2) Extended stop Add to stop All stops O2 window Break gas Stop rounding

Breathing

RMV bottom RMV deco Buddy RMV bottom Buddy RMV deco

ppO2 limits

Bottom: warning Bottom: critical (no plan above)

Gas switch depths (MOD) by O2 fraction:

≤ 28 % O2 28 – 45 % O2 45 – 99 % O2

Narcosis

END soft / hard m Density soft / hard g/L O2 narcotic

O2 toxicity

CNS limit %

Environment

Water

Advanced parameters

Travel → bottom switch, max depth (m) Water vapour (bar) Schreiner 0.0567
more conservativeStandard 0.0600Bühlmann 0.0627
less conservative

Manual stops Apply

Depth m, duration min, one per line. Imposed stops are recomputed into the plan. Too short a stop is shown in red with the GF reached at the next stop.

Tanks & gas lists

Gas lists: one block per list, "[Name]" then "bottom:" and "deco:" lines of O2/He mixes, deco mixes may carry "@minDepth". Tank presets: one per line "Name = litres, working pressure, reserve, max pressure" (bar). Saved in this browser.

Gas lists Off Board tanks Onboard tanks

Lost gasesTeam SoloTeam size×2 (team of 2) ×1.5 (team of 3) Use reserveTurn rule Time + minDepth + m

Choose Auto or Manual, set the dive and press Compute. After a change, press Compute again; only the Lost gases, Time + and Depth + controls recompute on their own.